NXOpen .NET Reference Guide
1899
|
Used by all the reports to hold the information of the segments under port, solid body, segment, stock, stock component, or feature representing the piece of stock. More...
Used by all the reports to hold the information of the segments under port, solid body, segment, stock, stock component, or feature representing the piece of stock.
Generated by calling Routing.BendReportManager.GetSegmentInformation .
NXOpen.Routing.BendCorner NXOpen.Routing.BendReportManager.SegmentInformation.BendCorner |
NXOpen.Point3d NXOpen.Routing.BendReportManager.SegmentInformation.BendPosition |
Position of the bend rcp
double NXOpen.Routing.BendReportManager.SegmentInformation.BendRadius |
Radius of the bend
NXOpen.Routing.ControlPoint NXOpen.Routing.BendReportManager.SegmentInformation.EndControlPoint |
End Routing.ControlPoint .
Do not use for S-Bends and bends greater than or equal to 180 degrees.
NXOpen.Point3d NXOpen.Routing.BendReportManager.SegmentInformation.EndControlPointPosition |
Location of end Routing.ControlPoint in ABS coordinates, use this instead of the end Routing.ControlPoint for S-Bends and bends greater than or equal to 180 degrees.
NXOpen.Vector3d NXOpen.Routing.BendReportManager.SegmentInformation.EndNormal |
Normal of curve at end points
bool NXOpen.Routing.BendReportManager.SegmentInformation.IsStraight |
True if the Routing.ISegment is straight.
double NXOpen.Routing.BendReportManager.SegmentInformation.Length |
Length of Routing.ISegment
NXOpen.Curve NXOpen.Routing.BendReportManager.SegmentInformation.Segment |
The segment itself.
NXOpen.Routing.ControlPoint NXOpen.Routing.BendReportManager.SegmentInformation.StartControlPoint |
Start Routing.ControlPoint .
Do not use for S-Bends and bends greater than or equal to 180 degrees.
NXOpen.Point3d NXOpen.Routing.BendReportManager.SegmentInformation.StartControlPointPosition |
Location of start Routing.ControlPoint in ABS coordinates, use this instead of the start Routing.ControlPoint for S-Bends and bends greater than or equal to 180 degrees.
NXOpen.Vector3d NXOpen.Routing.BendReportManager.SegmentInformation.StartNormal |
Normal of curve at start points
NXOpen.Routing.Stock NXOpen.Routing.BendReportManager.SegmentInformation.Stock |