public interface DupinBuilder extends TaggedObject, IComponentBuilder
Modifier and Type | Method and Description |
---|---|
Point |
analysisPoint()
Returns the point location defining where the analysis should be done.
|
double |
angle()
Returns the deviation in degrees from the minimum curvature.
|
double |
flatnessTolerance()
Returns the tolerance that defines at the specified point if an area is flat.
|
void |
resetAnalysisPoint()
Reset the analysis point to accept dynamic input.
|
double |
scale()
Returns the scale factor to apply to the display of the dupin indicatrix.
|
void |
setAnalysisPoint(Point analysisPoint)
License requirements: None. |
void |
setAngle(double angle)
License requirements: None. |
void |
setFlatnessTolerance(double flatnessTolerance)
License requirements: None. |
void |
setScale(double scale)
License requirements: None. |
printTestData, printTestData, tag, tagValue
validate
Point analysisPoint() throws NXException, RemoteException
NXException
RemoteException
void setAnalysisPoint(Point analysisPoint) throws NXException, RemoteException
analysisPoint
- NXException
RemoteException
void resetAnalysisPoint() throws NXException, RemoteException
NXException
RemoteException
double scale() throws NXException, RemoteException
NXException
RemoteException
void setScale(double scale) throws NXException, RemoteException
scale
- NXException
RemoteException
double angle() throws NXException, RemoteException
NXException
RemoteException
void setAngle(double angle) throws NXException, RemoteException
angle
- NXException
RemoteException
double flatnessTolerance() throws NXException, RemoteException
NXException
RemoteException
void setFlatnessTolerance(double flatnessTolerance) throws NXException, RemoteException
flatnessTolerance
- NXException
RemoteException
Copyright 2017 Siemens Product Lifecycle Management Software Inc. All Rights Reserved.